top of page
Pinhole & Porosity Inspection الكشف عن الثقوب و المسامية
Elcometer 260 UV Pinhole Flashlight
The Elcometer 260 UV Pinhole Flashlight is battery powered and housed in a rugged aluminium case providing a quick, low cost method of testing coatings for pinholes.
Elcometer 270 Pinhole Detector
The Elcometer 270 Pinhole Tester range utilises the wet sponge technique and has been designed to set a new standard for wet sponge pinhole detectors.
Elcometer 236 DC Holiday Detector
The Elcometer 236 Holiday Detector provides high voltage porosity testing to detect pits, flaws, holes, etc. in a wide variety of non-metallic coatings.
Elcometer 280 Pulsed DC Holiday Detector
The Elcometer 280 Pulsed DC Holiday Detector is a ‘stick type’ holiday detector that has been designed to make pulsed DC high voltage holiday detection safer, easier and more reliable than ever before.
Elcometer 266 Holiday Detector
The Elcometer 266 Holiday Detector revolutionises high voltage DC testing of coatings porosity detection making it safer, easier and more reliable than ever before.
Batteries and Chargers for High Voltage Detectors
A range of batteries and chargers designed to prolong the operational use of your high voltage holiday detector. Compatible with Elcometer 266 and 280 detectors, this range includes rechargable battery packs and battery chargers with the main leads providing the voltage required for your location.
Telescopic Probe Handles and Probe Extension Rods
This range of telescopic probe handles and extension rods allow you to test out of reach areas. The probe extension rods make it easier to test floors and large structures, or to test deeper inside pipelines.
Phosphor Bronze Rolling Springs
The Phosphor Bronze Rolling Spring is lightweight and flexible making it incredibly easy to manoeuvre, even on rough, uneven surfaces.
Stainless Steel Rolling Springs
Elcometer Stainless Steel Rolling Springs are robust, with flat, rectangular coils, ensuring that a large area of the probe is always in contact with the surface for thorough testing.
Band Brush Probes
The band brush probe is ideal for testing most applications and works especially well in small areas or on complex surfaces. The band brush probes are compatible with Elcometer 236, 266 and 280 detectors.
‘C-type’ Wire Brushes
‘C-type’ Wire Brushes are ideal for testing pinhole and porosity on the external side of a pipe. The ‘C-Type’ Wire Brush is lightweight, easy to use and ideal for testing the outside of pipes that have obstructions on them, such as valves or inspection hatches.
Wire Brush Probes and Electrodes
Elcometer supply a range of wire brush probes for internal and external pipe inspection, allowing for quick, accurate testing of large surface areas.
Conductive Rubber Probes
When testing on coatings that are more susceptible to scratches, rubber conductive probes preserve the coating and prevent damaging. Elcometer supply a range of conductive rubber probes, suitable for use on delicate materials where wire brush probes may not be appropriate.
Grounding Mats
Grounding mats are ideal for use when testing on ungrounded pipes. The conductive rubber mat is wrapped around the coated pipe and connected to both the grounding pin (supplied separately) and the signal return lead.
Earth Signal Return Leads
Elcometer Earth Signal Return Leads are compatible with the Elcometer 236, 266 and 280 detectors. Available in a range of sizes, please see part numbers for more information.
Accessory Adaptors
A range of accessory adaptors that allow other manufacturer's accessories to fit to Elcometer model's. Compatible with the Elcometer 236, 266 and 280, please see part numbers for more information.
bottom of page